AR 15 Magwell Mount - Slatwall | Rifle Holder Storage Rack

- Simple, Secure Mounting: Attaches to Slatwall via hook on the back of the mount and included printed T-nut and screw on bottom of mount. Insert printed nut into Slatwall slot underneath where you will place the hooked part of the mount. Rotate the nut 90 degrees to lock it into place. Then hook the mount into place and insert the screw through the bottom hole and into the printed nut. Tighten the screw to secure the mount to the slatwall.

- Ambidextrous: Firearm can be mounted facing left or right on the same mount.

- Wide Slatwall Compatibility: Variations available for Hold Up Displays, Savior Equipment, StoreWall, Patrick Industries / Decorative Dynamics "Slotwall", Menards Slatwall (specify with or without metal track insert), and generic Slatwall (blue, green, and red dimensions in the images below).

If you don't know your Slatwall type, order this bundle to test: https://hammy3dprints.com/products/slatwall-test-fitment-bundle-slatwall-magazine-holder-storage-rack

- Low Profile, Sleek Design: Proudly display your collection and make your firearm easy to access. The mount sits flush with the wall and holds the firearm for easy retrieval.

- Perfect Fitment: Works with AR 15 style firearms chambered in 223 / 5.56 / 300 /  etc. that utilize standard magazines, such as M2 / M3 Pmags. The "Mag Catch" version of this mount latches onto the mag catch/release which must be activated to remove the firearm from the mount. The "No Mag Catch" version does not latch onto the mag catch/release. The Inline Vertical version latches onto the mag catch and holds the firearm perpendicular to the mounting surface to allow for high-density storage.

- Original, Innovative Design: 1000+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

Note: The extended version holds the rifle further away from the gridwall to accommodate offset lights and optics. If you don't have one of these, the standard version is recommended.

NOTE: The Skinny - Metal version is too thin to use the nut and will instead be friction fit on the bottom.

Disclaimer: This product is not manufactured, authorized, endorsed, or warranted by Hold Up Displays or Savior Equipment or Menards® or StoreWALL. It is solely designed and produced by Hammy3DPrints.

MATERIAL: 3D printed using PLA+ filament.

INSTALLATION: Attaches to Slatwall via hook on the back of the mount and included printed T-nut and screw on bottom of mount.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.