Battery Cap Tool for Aimpoint Acro P2

- Specialized Fit: Fits into the battery cap slot of the Aimpoint Acro P2.

- Scratch Free: 3D-printed tool reduces the likelihood of damaging the plastic battery cap on the P2 or scratching your optic compared to a coin, screwdriver, or other metal-on-metal contact.

- Hand-Turn: Remove the battery cap by turning this tool with your hand.

- Usage Notes: Ensure you push the tool into the battery cap while you twist it. When re-tightening, go until it is snug and then stop. This is a plastic tool, and is not meant to tighten it like you'd tire a tire lug nut.

- Original, Innovative Design: 2200+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

Note: The cap in the photos was previously damaged by the provided Aimpoint tool. This tool was developed to prevent any further damage to the plastic cap.

Disclaimer: This product is not manufactured, authorized, endorsed, or warranted by Aimpoint. It is solely designed and produced by Hammy3DPrints.


MATERIAL: 3D printed using PLA+ filament. Note that this filament is not a high-temp filament rated for use inside vehicles left in direct sunlight during summer. If you require a higher-temp filament please contact me.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.