Friction-Fit Flared Magwell for B&T APC 9mm

- Easier Mag Insertion: The wide flare on this friction-fit magwell increases the area the mag can be pushed into the magwell by a significant amount.

- Friction-Fit: Precise design slides tightly on magwell bevel. This has been tested on an APC 9mm polymer lower that takes B&T mags. It is likely that this also fits the GHM and SPC 9mm, as well as the 10mm and 45 cal versions with polymer lowers for B&T mags.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA.

- Made in USA: 2200+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.