Friction-Fit Flared Magwell for Stribog SP9A3 9mm

Flared magwells for additional firearm models can be found here

- Easier Mag Insertion: The wide flare on this friction-fit magwell increases the area the mag can be pushed into the magwell by a significant amount.

- Friction-Fit: Precise design slides tightly on magwell bevel. This has been tested on the Stribog SP9A3 Stribog Mag lower only, but likely works on other 9mm Stribog SP9 models that take Stribog mags. It does not look like it'll fit the Glock mag versions.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA.

- Made in USA: 2200+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.