Killflash Anti-Reflection Device for Binoculars

- Precise Fit: You must have calipers ($8 on Amazon) to request a version for new binoculars. Each lens cover is sized specifically for each binocular model, within a few hundredths of an inch. This minimizes wiggling compared to Small/Medium/Large type generalized sizing.

- Securely Held To Binoculars: Attaches to binoculars via a tight friction-fit. This friction-fit can be difficult to achieve, thus I require the exact objective diameter as mentioned in the first bullet point.

- Fully Covers Lens: Protects your lenses from getting scratched when not in use by fully covering them. Also prevents glare caused by the lenses reflecting light. Due to needing to print with the front of the killflash on the print bed, there may be some shine to it which can be minimized by sanding or spray painting it.

- Pack of Two: Sold as a pack of two (2).

- Original Design: 2500+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

Disclaimer: I am not associated with any of the binocular manufacturers. These ARDs are made solely by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.