Mag Coupler for Colt / UZI 9mm Mags

Note: Ensure that coupled mags won't block the mag release from being pressed, such as on the UZI Pro

- Straps Mags Together: Carry a second mag without holding it or putting it in a mag pouch. Sturdy design that wraps around mags and lets you crank on the bolt and nut to tightly clamp the mags.

- Single vs Two-Piece:

• Single Piece: will not work with UZI's. Only works with AR9's or similar that use Colt Pattern / UZIs mags. This is due to the Single Piece version having to be installed above the side protrusions on the mags, which prevent it from entering an UZI grip/magwell.
• Two Piece: recommended option. Required for use with an UZI as the single piece won't slide down past the protrusions on the side of the mag. The two-piece can be installed underneath the protrusions and the baseplate as long as there is at least 1" of space. Also works with AR9's using Colt Pattern mags

- Simple Setup: Comes with coupler, a bolt, and a nut. The bolt and nut only fit in one way. It's easiest to push the nut fully into its slot and then thread the bolt in partially first.

- Perfect Fit: Designed specifically for AR9 Colt Pattern and Uzi 9mm mags.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA.

- Made in USA: 2000+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.