Mag Coupler for Glock 9mm/357/40 Mags

- Straps Mags Together: Carry a second mag without holding it or putting it in a mag pouch. If using my flared magwell, choose the Extended version so there is more space between the mags.

- For PCC Use: This will not work if the magazines have to be fully inserted into a Glock frame like 17 round mags into a G17, as the coupler takes up about 1" vertical space on the mag body. The mags must stick out at least 1" from the bottom of the frame/magwell.

- Tight Clamping: Sturdy design that wraps around mags lets you crank on the bolt and nut to tightly clamp the mags for no slippage. 

- Simple Setup: Comes with printed piece(s), a bolt, and a nut. The bolt and nut only fit in one way. Simply slide the mags in, then hold the nut in place with your finger while you tighten the bolt.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA.

- Perfect Fit: Designed specifically for Glock 17 / 19 / 22 / 23 / 24 / 26 / 27 / 31 / 32 / 33 / 34 / 35 / 45 / 47 magazines. Available as single piece or two-piece. Single piece is technically stronger, but either works great. The two-piece has open sides and comes with two halves.

- Made in USA: 2000+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.