Mag Coupler for MP5 .40 / 10mm Mags

- Straps Mags Together: Carry a second mag without holding it or putting it in a mag pouch. These couplers hold the mags far enough apart to accommodate my flared magwells.

- Tight Clamping: Sturdy design that wraps fully around mags lets you crank on the bolt and nut to tightly clamp the mags for no slippage. Available as a single piece or two-piece. The single piece is technically stronger, but both work great. For the single piece, insert the mags bottom first into the coupler.

- Simple Setup: Comes with printed piece(s), a bolt, and a nut. The bolt and nut only fit in one way. Simply slide the mags in, then hold the nut in place with your finger while you tighten the bolt.

- Perfect Fit: Works with either the original HK Germany mags (will say Made in Germany) or the US Reproduction HKP Clone mags depending on the selected version. Compatible with the MP5 .40 S&W, 10mm, .357 Sig, and 9x25mm Dilllon mags.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA.

- Made in USA: 2000+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.