Mag Coupler for Ruger 10/22 BX-1 Mags

- Straps Mags Together: Carry a second mag without holding it or putting it in a mag pouch.

- Friction-Fit: The mags must be pressed firmly onto the coupler, and can even be tapped up with a rubber mallet gently. As there is no room for anything on the rear of the mag to latch, it must be a tight fit.

- Front Clamp: On the front of the mags there are small indents, which the clamp piece interfaces with to connect the mags and the coupler. This clamp will prevent the mags from pulling apart, but on the rear of the mags there may be some separation due to lack of room for a latch on the back. 

- Simple Setup: Comes with printed coupler (with embedded heat-set insert), clamp, and bolt. Ensure the first mag is oriented properly (the heat-set insert should face the rear) and firmly push the mag onto the coupler. Tap them on with a rubber mallet if needed. Repeat to install the second mag. Then place the clamp into the indents on the front of the mags and install the bolt. Tighten until snug.

- Perfect Fit: Designed specifically for the 10-round BX-1 Ruger 10/22 rotary magazines.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA.

- Made in USA: 2500+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.