Mag Coupler for Ruger Mini-14 Mags

- Straps Mags Together: Carry a second mag without holding it or putting it in a mag pouch.

- Simple Setup: Comes with two printed pieces, a bolt, and a nut. The bolt and nut only fit in one way. The bolt should be on the front, and the nut on the back. put the halves on the mags as desired, then hold the nut in place with your finger while you tighten the bolt.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA.

- Specific Fit: Designed specifically for compatibility with Ruger Mini-14 magazines. Please note that these magazines are not made very precisely, so the mags will likely have some side-to-side wobble. The rear piece will be loose on some mags, and extremely tight on others.

- Made in USA: 2000+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.