Mag Coupler for Sig MPX 9mm Mags

- Straps Mags Together: Carry a second mag without holding it or putting it in a mag pouch.

- Tight Clamping: Sturdy design that wraps around mags lets you crank on the bolt and nut to tightly clamp the mags for no slippage. The front half also has protrusions to fit in the notches on the front of the magazines.

- Simple Setup: Comes as one printed piece, a bolt, and a nut. The bolts and nuts only fit in one way. Slide the top of the mags through the coupler, then hold the nut in place with your finger while you tighten the nut.

- Perfect Fit: The versions are specific to different mag types. Ensure your magazines match the selection option.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA.

- Made in USA: 2500+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.