Mag Coupler for Springfield Kuna 9mm Mags

Flared Magwell for the Kuna can be found here

- Straps Mags Together: Carry a second mag without holding it or putting it in a mag pouch. If using my flared magwell, choose the Extended version so there is more space between the mags.

- Tight Clamping: Sturdy design that wraps around mags and lets you crank on the bolt and nut to tightly clamp the mags for no slippage.

- Simple Setup: Comes with two printed halves, a bolt, and a nut. The bolt and nut only fit in one way. Separate the coupler into its two halves and insert the mags into one half of the coupler, ensuring the ridge on the coupler goes into one of the notches on the mags. Then put the other coupler half in position and tighten the bolt. Blue Loctite is recommended to be applied.

- Perfect Fit: Designed specifically for Springfield Kuna 9mm mags.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA.

- Made in USA: 2000+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.