MLOK Vertical Gun Mount - Slatwall | Rifle Holder Storage Rack

- Latchless Ambidextrous Design: Retrieve firearm with a single upward and outward motion. Firearm is securely held in place by gravity and cut-outs in the mount, safe from accidental bumps.

- Allows Magazine To Stay In Firearm: Be ready in a moment's notice. Unlike the vast majority of mounts, this leaves the magwell open for a magazine to stay inserted.

- Extremely Compatible: Works with any MLOK rail/handguard, regardless of platform. The extended version increases the distance between the wall and firearm from .9" to 1.6" to accommodate offset lights, red dots, lasers, etc. The 3-slot version uses 3 MLOK slots and is recommended wherever possible. The 2-slot version is good for smaller firearms where there are not as many open MLOK slots.

- Simple, Secure Mounting: Attaches to Slatwall via hook on the back of the mount and included printed T-nut and screw on bottom of mount. Insert printed nut into Slatwall slot underneath where you will place the hooked part of the mount. Rotate the nut 90 degrees to lock it into place. Then hook the mount into place and insert the screw through the bottom hole and into the printed nut. Tighten the screw to secure the mount to the slatwall.

- Wide Slatwall Compatibility: Variations available for Hold Up Displays, Savior Equipment, StoreWall, Patrick Industries / Decorative Dynamics "Slotwall", Menards Slatwall (specify with or without metal track insert), and generic Slatwall (blue, green, and red dimensions in the images below).

If you don't know your Slatwall type, order this bundle to test: https://hammy3dprints.com/products/slatwall-test-fitment-bundle-slatwall-magazine-holder-storage-rack

- Original, Innovative Design: Support the original designer of the mount, Hammy3DPrints, rather than the lower-quality knock-offs. Designed and 3D printed in the heart of America in St Louis, Missouri.

NOTE: The Skinny - Metal version is too thin to use the nut and will instead be friction fit on the bottom.

Disclaimer: This product is not manufactured, authorized, endorsed, or warranted by Hold Up Displays or Savior Equipment or Menards® or StoreWALL. It is solely designed and produced by Hammy3DPrints.

MATERIAL: 3D printed using PLA+ filament.

INSTALLATION: Attaches to Slatwall via hook on the back of the mount and included printed T-nut and screw on bottom of mount.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.