Mag Coupler for HK MP5 22LR Mags

- Straps Mags Together: Carry a second mag without holding it or putting it in a mag pouch.

- Tight Clamping: Sturdy design that wraps around mags and lets you crank on the bolt and nut to tightly clamp the mags for no slippage.

- Simple Setup: Comes with two printed pieces, bolt, and nut. The bolt and nut only fit in one way. It's easiest to push the nut fully into its slot and then thread the bolt in partially first. Then, slide the mags in bottom-first until the bottom of the mags are flush with the bottom of the coupler, then finish tightening the nut.

- Perfect Fit: Designed specifically for HK / Walther / Umarex MP5 22LR mags. The coupler goes as the bottom of the mags to not interfere with the pull-down loading tabs, and because the mags are so scrawny that the clamp can tighten enough to prevent the follower from going past the clamp. For these reasons, the clamp should go at the bottom of the mags as pictured. Sometimes, the mags may be limited to about 23 rounds due to the clamp at the bottom.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA.

- Made in USA: 2000+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.