Friction-Fit Flared Magwell for HK MP5 22LR

MP5 22LR mag couplers for use with flared magwells can be found here

Flared magwells for MP5 9mm models can be found here

Flared magwells for additional firearm models can be found here

This is ONLY for the HK / Umarex / Walther MP5 22LR version. Click here for flared magwells for 9mm MP5 variants.

- Easier Mag Insertion: The wide flare on this friction-fit magwell increases the area the mag can be pushed into the magwell by a significant amount. It is designed to precisely align with the existing magwell for a seamless magazine insertion.

- Friction-Fit: Precise design slides tightly over magwell bevel. Due to the exact fit, it will only fit the exact HK MP5 22LR model, not the GSG or any 9mm variants. Note: This magwell does not interfere with the paddle mag release. It functions normally.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA+.

- Outer Flared Magwell Dimensions:  1.85" x 1.67" x 0.59"

- Installation: Follow these instructions carefully, noting that the "right" side is the ejection port side, and "front" is towards the barrel:

• Place the front-right corner of the flared magwell into position, lining up the rounded protrusion on the right side of the flared magwell with the dimple on the right side of the receiver. Hold the magwell in place with your right thumb and index finger, and use your right palm to push the left side of the flared magwell over the left side of the receiver, applying pressure from the bottom of the magwell. You should hear it seat with a satisfying sound.

- Made in USA: 2500+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks, I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.