Friction-Fit Flared Magwell for MP5 / MP5K

MP5 mag couplers for use with flared magwells can be found here

Flared magwells for the 22LR version of the MP5 can be found here

Flared magwells for additional firearm models can be found here

If you have an MP5 model not listed and are willing to test magwells with me to get one to fit, please contact me.

Please note that MP5 receivers vary significantly. If your exact model isn't listed, it will likely not fit (for example: POF). They can even vary within model lines. At the end of the day, they are made from folded and welded metal flats and are not always precise. If you ordered the correct flared magwell model for your firearm, but it doesn't fit, please send a video of the issue to hammy3dprints@gmail.com

- Easier Mag Insertion: The wide flare on these friction-fit magwells increases the area the mag can be pushed into the magwell by a significant amount. They are designed to precisely align with the existing magwell for a seamless magazine insertion (MP5 magwells are not always perfectly rectangular, though). They are compatible with my magazine couplers linked above.

- Friction-Fit: Precise design slides tightly over magwell bevel. Due to the exact fit, it will only fit the exact models selected from the Style selections. Note: This magwell does not interfere with the paddle mag release. It functions normally.

- Sling Hook Notch: The sling hook on many MP5 receivers requires a notch on the left side of the flared magwell. Due to the inconsistencies in the sling hook location, the notch is purposely oversized to accommodate variations.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA+.

- Outer Flared Magwell Dimensions:  1.85" x 1.67" x 0.59"

- Installation: The installation steps depend on which MP5 variant you have. MP5 receivers vary significantly, and these magwells are extremely precise to snap into place. Follow these instructions carefully, noting that the "right" side is the ejection port side, and "front" is towards the barrel.

• All Except HK SP5 / SP5K: Place the left side of the flared magwell into position, lining up the notch in the flared magwell with the sling hook (if present) and the protrusion further back on the left side over the receiver lip. With the left side of the flared magwell in position, hold it in place with your right index finger, middle finger, and thumb. Use your thumb and part of your palm to push the bottom of the magwell over the right side of the receiver. You should hear it seat with a satisfying sound.
  
• HK SP5 / SP5K: Place the front-right corner of the flared magwell into position, lining up the rounded protrusion on the right side of the flared magwell with the dimple on the right side of the receiver. Hold the magwell in place with your right thumb and index finger, and use your right palm to push the left side of the flared magwell over the left side of the receiver, applying pressure from the bottom of the magwell. You should hear it seat with a satisfying sound.

- Made in USA: 2500+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks, I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.