Mag Coupler for MP5 9mm Metal Mags

Flared magwells for MP5s can be found here

A coupler for Overwatch Precision MOD2 MP5 mags is here

A coupler for AC Unity 40 round mags is here

- Straps Mags Together: Carry a second mag without holding it or putting it in a mag pouch. These couplers hold the mags far enough apart to accommodate my flared magwells.

- Tight Clamping: Sturdy design that wraps fully around mags lets you crank on the bolt and nut to tightly clamp the mags for no slippage. Available as a single piece or two-piece. The single piece is technically stronger, but both work great. For the single piece, insert the mags bottom first into the coupler.

- Simple Setup: Comes with printed piece(s), a bolt, and a nut. The bolt and nut only fit in one way. Simply slide the mags in, then hold the nut in place with your finger while you tighten the bolt.

- Perfect Fit: Works with both the classic straight HK MP5 9mm mags and curved metal HK / POF / Zenith / KCI / etc. magazines. 

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA.

- Made in USA: 2000+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.