Mag Coupler for P90 Mags

- Straps Mags Together: Carry a second mag without holding it or putting it in a mag pouch.

- Simple Setup: Comes with two printed pieces, two M4 x 55mm bolts, and two nuts. The bolts and nuts only fit in one way. Put the halves on the mags as desired, then hold a nut in place with your finger while you tighten a bolt into it. Repeat for the other bolt and nut.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA.

- Requires Optic: The increased height of the cheek weld due to the second mag above the stock requires the use of an optic. It will block the ring sight.

- Specific Fit: Designed specifically for compatibility with an FN P90 / PS90 and their magazines. For a version that works with the Keltec P50 / Stuff And Things ST-50, see here.

- Made in USA: 2000+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

Disclaimer: This product is not manufactured, authorized, endorsed, or warranted by Keltec or Stuff And Things Inc/LLC. It is solely designed and produced by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.