Mag Coupler for P90 Mags - Keltec P50 / ST-50 Version

- Straps Mags Together: Carry a second mag without holding it or putting it in a mag pouch.

- Simple Setup: Comes with four printed pieces, two bolts, and two nuts. The bolts and nuts only fit in one way. Put two halves on the mags as desired, then hold a nut in place with your finger while you tighten a bolt into it. Repeat for the other set. Note that the couplers should have quite a bit of distance between them to prevent the mags from flexing together or apart.

- PETG-CF Material: Printed out of higher temp-resistant material than standard PLA.

- Specific Fit: Designed specifically for compatibility with the Keltec P50 or Stuff And Things ST-50 using P90 mags. For a version that works with the FN P90 / PS90, see here.

- Made in USA: 2000+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.

Disclaimer: This product is not manufactured, authorized, endorsed, or warranted by Keltec or Stuff And Things Inc/LLC. It is solely designed and produced by Hammy3DPrints.

MATERIAL: 3D printed using PETG-CF filament.

WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.

Made in USA.

Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.